Includes: clean and inspect internally, remove sheet metal from sides, check and repair insulation as needed, recover sides with prepainted white aluminum sheets, repaint heads and leg supports, install new 1.5 HP Copeland R-404A refrigeration unit with all new refrigeration line components. Cutler Hammer electrical panel with fused disconnect, motor starter, control voltage transformer, Allen Bradley pressure switch and all other components necessary for automatic operation, new single bleeder, new dual ASME safeties (sized for outdoor installation), new Jamesbury (Eliminator) stainless steel ball valves installed on one each 1” vapor balance and 1.5” liquid fill lines (w/new CGA fittings and 1/2" hose blow-down valves), 1” vapor and 1” liquid process lines and three ½” instrument isolation valves, rebuilt Barton liquid level indicator, new 6" 0-600 psi pressure indicator, fabricate small cover over the refrigeration unit and complete check out with all controls set for proper operation.
Vessel Serial Number #19321 (516 steel)
    

Includes: Clean and inspect internally, check insulation, cover sides using pre-painted white aluminum sheets with a new carbon steel bottom section, repaint front and rear heads, install new 2 HP Copeland R-404A refrigeration unit with all new refrigeration line components, Cutler Hammer electrical panel with fused disconnect, motor starter, control voltage transformer, Allen Bradley pressure switch and all other components necessary for automatic operation, new dual bleeders, new dual ASME safeties (sized for outdoor installation), new Jamesbury (Eliminator) stainless steel ball valves on one each 1" vapor balance and 1.5" liquid fill lines (w/new CGA fittings and hose blow-down valves), 1" vapor and 1" liquid process lines and three 1/2" instrument isolation valves, rebuilt Barton liquid level indicator and new 6" 0-600 psi pressure indicator.  Complete check out with all controls set for proper operation. 
National Board #43974 (515 steel)
 

Price Includes: Clean and inspect internally, remove sheet metal from sides, check and repair insulation as needed, recover sides with prepainted white aluminum sheets, repaint heads, new modular 6HP Copeland R404A refrigeration unit with all new line components, Cutler Hammer electrical panel with fused disconnect, motor starter, control voltage transformer, Allen Bradley pressure switch and all other components necessary for automatic operation, new dual bleeders, new dual ASME safeties (sized for outdoor installation), new Jamesbury (Eliminator) stainless steel ball valves installed on 1" each vapor balance and 1.5" liquid fill lines w/CGA fittings and 1/2" hose blow-down valves, and 1" vapor and 1" liquid process lines and three 1/2" instrument isolation valves, rebuilt existing Barton liquid level indicator, new 6" 0-600 psi pressure indicator. Complete check out with all controls set for proper operation. NOTE: 280PSI MAWP
National Board #2040 (515 steel)

NOTE: The price includes testing the refrigeration system, instruments and all valves with liquid carbon dioxide in the vessel for a minimum of 48 hours.  After testing, the refrigeration charge (R-404A) will be pumped into the reservoir and sealed off.  The lines will be cut and capped for shipment.  Connecting the system on site will be done by others and requires connecting all lines, pulling a vacuum on all lines, opening the service valves to release the charge, monitoring the system during the first few cycles to insure everything is running perfectly.  Some fine tuning may be required as actual conditions may differ from test conditions.  If this work is not done properly it could result in problems that are beyond our control.  Therefore, it should only be performed by a qualified refrigeration technician.

NB: 30 (612 steel) and NB: 13057 (516 steel)